Parting
General Information
The SE groove turning system with ACS (ARNO Cooling System) optimizes the turning and groove turning operations. This system is an economical and efficient solution to radial grooving and parting off in widths from 2 - 6mm, depth capacity of either 12 or 21mm and maximum diameter up to 140mm. The mono block holders are available with coolant inlet either through the side, from the rear or from the bottom of the tool. Inserts are available in 3 different geometries.
All holders are equipped with the well-known ARNO-ACS cooling system®. This very effective coolant system ensures the coolant sprays under the swarf and thereby improves tool life considerably.
Geometry
The SE groove turning system with ACS (ARNO Cooling System) optimizes the turning and groove turning operations. This system is an economical and efficient solution to radial grooving and parting off in widths from 2 - 6mm, depth capacity of either 12 or 21mm and maximum diameter up to 140mm. The mono block holders are available with coolant inlet either through the side, from the rear or from the bottom of the tool. Inserts are available in 3 different geometries.
All holders are equipped with the well-known ARNO-ACS cooling system®. This very effective coolant system ensures the coolant sprays under the swarf and thereby improves tool life considerably.
Details
- Effective and easy to use
- NEW: holder with ACS for auto lathe machining
- NEW: holder with insert locking from top and bottom
- Mechanical insert clamping with fixed stop
- Accurate inserts positioning due to double prism location
- Inserts will not be “pulled” out
- Double sided inserts with application specific geometries ensures excellent economic benefits
- An exceptional and cost efficient solution for groove turning
Geometry
M2:
- First choice for grooving and turning
- Main application for steel and stainless steel
- Strong cutting edge for maximum feed rates and cutting depths
T1:
- Very good swarf control and formation
- For steel and stainless steel
- Universal geometry machining, for thin-walled components
ALU:
- Geometry with a sharp edge
- First choice for aluminium and non-ferrous materials
- Periphery ground insert
- High positive design
- Polished chip breakers